CDX Quick Assembly Instructions:
1. Carefully unpack all parts.
2. Unscrew the spindle and bolt (Note: it is reverse-threaded!)
3. Place the platter on the CDX, aligning the 2 pins on the platter with
the 2 holes on the CDX motor.
4. Place slipmat and record on platter.
5. Rotate spindle center “D” shaft to point
to 1 of the 3 record holes as shown:
6. Place the record cap on the record, and line up the “D”-shaped
spindle slot and pins with the record holes and “D” shaft.
7. Screw on the spindle and washer in the reverse (counter-
clockwise) direction.
8. Use wrench to carefully tighten, but not over-tighten the spindle.
To Next Page
Need help?
General
