Contents [ hide
1 Introduction
1.1 Box Contents
1.2 Support
2 Setup
2.1 Connection Diagram
3 Features
3.1 Front Panel
3.2 Rear Panel
3.3 Display
4 Operation
4.1 Performance Pad
Modes
5 File Downloads
6 References
7 Related Manuals
Introduction
Box Contents
MixTrack Platinum FX
USB Cable
Software Download Card
User Guide
Safety & Warranty Manual
Support
For the latest information about this product (system requirements, compatibility information, etc.) and product
registration, visit numark.com.
For additional product support, visit numark.com/support.
Setup
1. Place MixTrack Platinum FX on a flat, stable surface.
2. Make sure all devices are turned off and all faders and gain knobs are set to “zero”.
3. If using a microphone, connect it to MixTrack Platinum FX’s microphone input.
4. Connect MixTrack Platinum FX’s outputs to power amplifiers, tape decks, and/or other audio sources.
5. Plug all devices into AC power and connect MixTrack Platinum FX’s USB port to a computer’s USB port using
the included USB cable.
6. When powering everything on, power on your devices in the following order:
(1) Your computer, (2) any amplifiers, speakers, or output devices
7. Locate the Serato DJ Lite installation card in the box to download and install the software.
8. Open your software program and load music to the decks.
9. Start DJ’ing!
10. When powering everything off, power off your devices in the following order:
(1) Any amplifiers, speakers, or output devices, (2) your computer
Connection Diagram
Items not listed under Introduction > Box Contents are sold separately.
To Next Page
Loading...
Need help?
General
