Features
Top Panel
1. Browse Knob: Rotate this knob to cycle through folders and tracks. Press the knob to cycle between the
Crates and Library.
Hold Shift and rotate the knob to quickly scroll through tracks and folders.
2. Master Gain: Adjusts the master volume in the software.
Note: This control does not affect the microphone volume, which is summed with the final output of the
Master Gain to the Master Output. Use the Mic Gain knob to control the microphone volume.
3. Mic Gain: Adjusts the level for the microphone input.
4. Cue Mix: Adjusts the audio output to the headphones, mixing between the cue output and the master mix
output.
5. Cue Gain: Adjusts the volume for headphone cueing.
6. Master Output LEDs: Displays the audio level going to the Master Output.
7. Load: Press one of these buttons while a track is selected to assign it to Deck 1 or 2, respectively. Quickly
double-press a Load button to assign the same track on both decks.
8. Level: Adjusts the pre-fader, pre-EQ audio level of the corresponding channel.
9. High EQ: Controls the treble frequencies for the individual channels.
10. Mid EQ: Controls the mid-range frequencies for the individual channels.
11. Low EQ: Controls the bass frequencies for the individual channels.
12. Filter: Adjusts the amount of the filter effect. Turning the knob left and right will produce a lowpass filter and
high-pass filter, respectively.
13. Cue/PFL: Sends pre-fader audio to the cue channel for headphone monitoring.
14. Channel Fader: Adjusts the volume of the individual channels in the software.
15. Crossfader: Controls the blend between the two decks.
16. Pitch Bend Down: Press and hold to momentarily reduce the speed of the track.
To Next Page
Loading...
Need help?
General
