Numark MIXTRACK PLATINUM FX - Operation; Performance Pad Modes; File Downloads; References

these segments will flash to give a warning.
Operation
Performance Pad Modes
The upper row of pads has different functions depending on their mode: Cue, Auto Loop Mode, Fader Cuts, and
Sample Mode. To select a mode, press one of the Pad mode buttons and press one of the upper pads to activate a
specific function.
Cue Mode: Press the pad marked Cue and press a lit pad from the upper 4 pads to return a track to the assigned
Hot Cue Point. Press an unlit pad from the upper 4 pads to assign a Hot Cue Point at the desired point in your track.
Auto Loop Mode: Press the pad marked Auto Loop to assign the upper 4 pads to the functions listed below:
Auto 1: Sets and starts playback of a 1-beat auto loop. Press Shift + Auto 1 to set and start playback of a
1/16-beat loop roll.
Auto 2: Sets and starts playback of a 2-beat auto loop. Press Shift + Auto 2 to set and start playback of a 1/8-
beat loop roll.
Auto 4: Sets and starts playback of a 4-beat auto loop. Press Shift + Auto 4 to set and start playback of a 1/4-
beat loop roll.
Auto 8: Sets and starts playback of an 8-beat auto loop. Press Shift + Auto 8 to set and start playback of a
1/2-beat loop roll.
Fader Cuts: The pads will mute and unmute the deck’s audio signal in a way that emulates crossfader movements
toward that deck.
Sample Mode: Press the pad marked Sampler to assign the upper 4 pads to play a sample. Press Shift and one of
the upper four pads to stop playback, or to load a sample if the slot is empty.
File Downloads
Numark User Guide
MIXTRACK Platinum FX
Download [optimized]
Download
References
Support | Numark
Numark
Related Manuals