Securing Child
With Built-in Harness (Rear/Forward Facing)
Loosen and unbuckle harness. Retain with magnetic
buckle tongue holders (p.22).
1 - Place child in child restraint with child’s back flat
against child restraint seat back. DO NOT allow
child to slouch.
If child's head falls forward, recline the seat more.
2 - For rear facing use, adjust head support (p.30) to
position harness AT or just below shoulders.
For forward facing use, adjust head support (p.30)
to position harness AT or just above shoulders.
Adjust harness buckle to fit child (p.28). Harness
buckle should be close to, but not under child.
Position harness over child’s shoulders and around
child’s waist, and buckle harness.
3 - Remove slack from shoulder straps and waist belt
by pulling up on shoulder straps (1). Pull harness
adjustment strap (2) to tighten. Harness should fit
snugly on child's shoulders and thighs; it is snug if
you cannot pinch a fold in the strap horizontally.
Fasten and position chest clip (p.22) level with
child’s armpits (3).
WARNING: If your child is not properly
secured in the child restraint, they may be ejected
in a crash, resulting in serious injury or death.
A snug strap should not allow any slack. It lies in
a relatively straight line without sagging. It does
not press on the child's flesh or push the child's
body into an unnatural position.
3
2
1
Rear Facing:
Harness AT or just
below shoulders
Forward Facing:
Harness AT or
just above shoulders
66 EXEC
™
instructions
1
2
3
67EXEC
™
instructions
To Next Page
Loading...
Need help?
General
