Nuna Exec User Manual

Without Built-in Harness (Booster)
Make sure the harness and harness buckle are
stored inside the seat (p.40).
With the booster installed in the vehicle, have the
child sit in the booster with their back flat against
the booster seat back.
1 - Route the vehicle belt across the child’s chest
and through the PURPLE lower belt path
toward the vehicle buckle.
2 - Secure the vehicle buckle and listen for a
“click.” Pull up on vehicle belt to remove slack.
3 - Route the vehicle shoulder belt through the
PURPLE shoulder belt guide (p.40).
4 - Adjust the head support (p.30). The correct
head support height is obtained when the vehicle
shoulder belt is:
• between the child's neck and shoulder
• flat across the center of the child's chest.
Bottom of head support will be approximately
even with the top of child's shoulders.
The vehicle shoulder belt MUST:
• route completely through the guide
• lie between the child's neck and shoulder
• not fall off the child’s shoulder
The vehicle lap belt MUST lie flat and snug
across the child's thighs.
click
68 EXEC
™
instructions
3
2
69EXEC
™
instructions
1
4

Nuna Exec Specifications

General

Recline positions	8 positions
Adjustable headrest	Yes
Orientation	Rear-facing and forward-facing
Safety features	Side-impact protection, energy-absorbing foam
Product Weight	26.6 lbs
Expiration	10 years
Safety Standards	FMVSS 213 certified
Installation method	Belt path, LATCH