Accessory
Car Seat Adaptors (sold separately)
NUNA KLIK plus infant carrier can be used with PEPP next
using the car seat adaptors.
For KLIK plus infant carrier assembly and usage, please refer
to the infant carrier instruction manual.
Before attaching the car seat adaptors, remove the canopy.
(16)
1 - Unfasten the hook and loop from the side of the seat
frame. (32)
2 - Pull and unsnap the fabric from the seat frame. (33)
3 - Unlatch and open the infant car seat adaptors, locating
the numbers on the inside. (34)
4 - Place infant car seat adaptor 1 around the left side of the
seat frame, with the arrow pointing down. The number
should be under the seat frame and the adaptor should
align with the gray lines on the top of the seat frame.
(35)
5 - Close the infant car seat adaptor over the top of the seat
frame. (36)
6 - Pull the adaptor end toward the seat frame. A “click”
sound means the car seat adaptor is attached. (37)
7 - Repeat on the right side with infant car seat adaptor 2.
Use Tether Strap
Use the tether strap to prevent the stroller inadvertently
rolling away. Check that when your hand is through the loop,
it allows you to easily control the stroller. (28)
Fold
Before folding the stroller, push the canopy to the rear of
the stroller, adjust the handle to the lowest position and
separate the storage latch from the lower storage mount.
1 - Pull up on the folding buttons (29)-1 and push the
stroller forward to fold (29)-2.
2 - Secure the storage latch to the upper storage mount.
(30)
3 - You can carry the stroller by lifting its handle. (31)
Ensure the storage latch is engaged when lifting or
carrying the stroller.
15 PEPP next instructions 16PEPP next instructions
To Next Page
Loading...
Need help?
General
