1514
PIPA lite lx Instructions
PIPA lite lx Instructions
EN
EN
Seat Pad
1
- Open the snaps on both sides of the seat. (9)
2 - Press the red button to disengage the buckle.
Remove the body support.
3 - Remove the seat pad. (10)
Installation concerns
DO NOT install this infant child restraint on
vehicle seats with 2-Point Retractor Safety
Belts with the Base. (11)
This infant child restraint is suitable for vehicle
seats with a 3-point Retractor Safety Belt with
the Base (12), or ISOFIX anchor points WITH
the Base. (13)
DO NOT place rear-facing child restraint on
front seat with air bag. Death or serious injury
may occur. (14) Please reference vehicle
owner’s manual for more information.
DO NOT install this infant child restraint on
vehicle seats that face sideways or rearward
with respect to the moving direction of the
vehicle. (15)
It is recommended to install this infant child
restraint on the rear vehicle seat. (16)
DO NOT install this infant child restraint on
vehicle seats unstable during installation.
Product Overview
Canopy
1
- To assemble the canopy, push canopy mounts
into fabric slot to attach to the seat. (1) A click
sound means the canopy mounts is locked
completely. (2)
2 - Stick the hook and loop fasteners on the rear
of canopy and seat. (3)
3 - Snap the canopy to the canopy mount on both
sides. (4)
4 - To open the canopy, pull the canopy toward
the front of the seat, and to close the canopy,
push it back.
5 - To remove the canopy, reverse step 1. Then
unsnap the seat pad from the shell and lift
fabric up. (5)
6 - Press the canopy release button (6)-1 and pull
canopy through the fabric slot. (6)-2 Repeat on
opposite side.
Dream Drape
™
1 - Unzip the zipper behind the front canopy bow.
(7)
2 -
Pull the dream drape
™
out of the compartment.
(8)
Attach the dream drape
™
to the magnets on each
corner to the front of the carrier.
To Next Page
Loading...
Need help?
General
