2524
PIPA lite lx Instructions
PIPA lite lx Instructions
EN
EN
6 - To release the Child Restraint, pull the infant
carrier up (57)-2 while squeezing the infant
carrier release button located on the base.
(57)-1
7 - To remove the base, lift up on the the lock off.
(58)
8 - Unbuckle the vehicle belt and un-route the
shoulder and lap belt from the base. (59)
Then remove the base.
Installation on a Stroller
This infant carrier can attach to Nuna strollers
using adapters. Instructions are included with the
adapters, which are sold separately.
This infant carrier can also attach to other brands
of strollers using adapters. Please visit nuna.eu for
more information.
Cleaning and Maintenance
Your infant carrier is a valuable piece of equipment
and deserves careful handling.
For reasons of safety, only use original Nuna parts.
Refer to the care label attached to the soft goods
for washing and drying instructions.
Use only mild detergent, water and a soft cloth to
clean the infant carrier shell, handle and harness
straps. Air dry.
To clean the buckle: rinse using warm water. DO
NOT use any soaps, solvents or lubricants. Using
anything other than water can cause the buckle to
malfunction. Air dry.
Remove the infant child restraint from the vehicle
seat if not in use for a long period of time. Put
the infant child restraint in a cool, dry place and
somewhere your child can not access it.
It is normal for fabric to color from sunlight and to
show wear and tear after a long period of use, even
when used normally.
Check regularly if everything functions properly.
If any parts are torn, broken, or missing, stop using
this product.
©2018 Nuna International B.V. Nuna and all
associated logos are trademarks
To Next Page
Loading...
Need help?
General
