Head and Body Support
The head and body supports can be used as
necessary, to provide a snug fit for small babies.
The head support straps cannot go through the
same slots as the harness and should only be
used in the top two harness slot positions.
1 - To remove the head support, unfasten the hook
and loop ends behind the seat fabric.
2 - Then, pull the head support straps through the
harness slots.
3 - To remove, the body support, unbuckle the
harness and route the buckle and crotch belt
through the bottom slot of the body support.
4 - The low birth weight pillow (located on the
back of the body support) can be used in the
body support for even smaller babies, but
MUST be removed once a snug fit can be
achieved without it, at approximately 11 lbs.
5 - To remove the low birth weight pillow, unfasten
the hook and loop on the back of the body
support and pull out the pillow.
1
2
3
4
5
21PIPA lite series instructions20 PIPA lite series instructions
To Next Page
Loading...
Need help?
General
