Nuna Pipa Lite Series User Manual

1
2
3
4
5
43PIPA lite series instructions42 PIPA lite series instructions
Stability Leg
Refer to vehicle owner’s manual to determine if
stability leg can be used over a vehicle storage
compartment.
1 - Unfold the stability leg from the stability leg
storage.
2 - After correctly installing the base on the vehicle
seat, press the stability leg adjustment button
to extend the stability leg to the floor.
3 - Stability leg should make firm contact with the
vehicle floor.
4 - Indicators should show green.
When the stability leg indicator shows red this
means the stability leg is in the wrong position.
Make sure the stability leg is secure and makes
firm contact with the vehicle floor. The stability
leg indicator shows green when it is properly
contacting the floor of the vehicle.
5 - DO NOT use if stability leg lifts base off seat.
DO NOT use stability leg to recline the base.
The recline adjustment feature is meant to
recline the base.
Always store stability leg when not in use.
This seat is safe to use with stability leg in use
or stored for both rigid LATCH or vehicle belt
installation.

Nuna Pipa Lite Series Specifications

General

Usage	4 to 32 lbs, up to 32 inches
Safety Features	Side impact protection
Base	Included
Material	Lightweight aerospace aluminum
Compatibility	Nuna strollers
Harness	5-point harness
Safety Standards	Meets or exceeds FMVSS 213
Weight	5.3 lbs