Nuna Pipa - Base Install - Rigid LATCH

1 - Rotate Rigid LATCH (lower attachments) down.
2 - Hook Rigid LATCH onto vehicle LATCH lower
anchor bars.
3 - Confirm proper installation by pulling on the
base AND also seeing that green is indicated
on the connectors.
The Rigid LATCH (lower attachments) must be
attached and locked onto the vehicle anchor bars.
Check Installation
Base should not move side to side or forward
more than 1” at belt path.
Bubble must be touching line. Use recline
adjustment, if needed, to position bubble.
It is acceptable to install with both LATCH (lower
attachments) and the vehicle belt.
Attaching Child Restraint to Base
4 - After child is properly secured in child
restraint, press child restraint on base and
listen for a click. Pull on child restraint to verify
installation.
DO NOT allow child restraint to contact the
vehicle interior (side of car or seat in front)
when installed.
5 - To release the child restraint, squeeze the car
seat release button (1) located on the base,
while pulling the child restraint up (2).
2
1
1
2
3
4
5
35PIPA instructions34 PIPA instructions
click
click
click