Installation
If child is not secured properly, child could
be ejected in a sudden stop or crash, resulting
in serious injury or death.
Base Installation Using Rigid LATCH
(Lower Attachments)
1
- Place vehicle in park and on level ground.
2 - Position base in a forward facing vehicle seat.
Use recline adjustment to position bubble in
indicator. Adjust base so bubble touches line.
3 - Use recline adjustment to achieve correct
angle for installation. Recline adjustment locks
into position.
4 - To release press down on lock button.
5 - When installing with the base, additional
stability can be achieved by using the stability
leg. For instructions on using the stability
leg when installing the base, see stability leg
section.
6 - If necessary, install rigid LATCH guides on
vehicle LATCH lower anchor bars.
1
2
3
4
5
6
32 PIPA instructions 33PIPA instructions
To Next Page
Loading...
