1 - After child is properly secured in child
restraint, press child restraint on base and
listen for a click. Pull on child restraint to verify
installation.
DO NOT allow child restraint to contact the
vehicle door or seat in front of it.
2 - To release the child restraint, squeeze the car
seat release button (1) located on the base,
while pulling the child restraint up (2).
3 - To remove the base, lift up on the lock off.
4 - Unbuckle the vehicle belt and un-route the
shoulder and lap belt from the base.
Then remove the base.
Stability Leg
Refer to vehicle owner’s manual to determine if
stability leg can be used over a vehicle storage
compartment.
5 - Unfold the stability leg from storage
compartment.
6 - Do not use if stability leg lifts base off seat.
Do not use stability leg to recline the base.
The recline adjustment feature is meant to
recline the base.
Always store stability leg when not in use.
2
2
2
1
1
2
3
4
5
6
41PIPA instructions40 PIPA instructions
click
To Next Page
Loading...
