23
•
This seat is safe to use with stability leg in use or stored for
both rigid LATCH and vehicle belt installation.
Carrier only install
1 Place vehicle in park and on level
ground.
2 Position carrier so that child
is facing the rear of the vehicle.
Only install in a forward
facing vehicle seat. (Page 6)
3 Route the vehicle lap belt under both
lap belt guides and buckle the vehicle
belt.
4 Route the shoulder belt around the
back of the carrier passing through
the blue shoulder belt guide.
•
If you are unable to route the shoulder
belt around the back of the carrier,
use only the lap belt. Allow shoulder
belt to lay against vehicle seat back
as shown.
• If your vehicle only has a lap belt,
shoulder belt will not be used.
To Next Page
Loading...
