25
MYTHOS
EN
It is not possible to set a standby value above that set for normal operation
and therefore, any value can be increased as far as the normal operating
value.
7.4.11
LANGUAGE SELECTION
During programming it is possible to choose the language (Italian, English, French, German,
Spanish) using the flashing key
; each time the key is pressed, this selects the mode
shown in the centre of the display.
When the
key is pressed again, this quits the programming function.
To quit programming at any time without having to view all the steps, press and hold down
the
key for 5 seconds.
7.4.12 ADJUSTING LIGHTING DURING NORMAL OPERATION
If the keys and are held down for 8 seconds from the language select screen, this
will open the lighting adjustment function for the keys and the display.
Pressing this key, it is possible to change the lighting of the “NON ACTIVE” keys on
a scale from 0 to 10, indicated by "Tm".
Pressing this key, it is possible to change the lighting of the “ACTIVE” keys on a scale
from 0 to 10, indicated by "TM".
Pressing this key, it is possible to change the lighting of the display on a scale from
0 to 7, indicated by "D".
Pressing this key at this stage of adjustment proceeds with operations by storing the
set values to memory.
7.4.13 ADJUSTING LIGHTING DURING STANDBY
Pressing this key, it is possible to change the lighting of the "NON ACTIVE" keys in
standby on a scale from 0 to 10, indicated by "Tm".
Pressing this key, it is possible to change the lighting of the "NON ACTIVE" keys in
standby on a scale from 0 to 10, indicated by "Tm".
67$1'%</,*+7$'-867
7P70'
&+226(/$1*8$*(
(1*/,6+
!
1250$//,*+7$'-867
7P70'
To Next Page
Loading...
Need help?
General
