Operating Instruction and Documentation
Sprinter Mobil 3000
- 24 -
Level of the oil is too low
gear pump does not work
The pressure control valve is defective
Refill if necessary.
Lower the lift in the lowest position.
Remove the cover of the hydraulic unit.
After the fill the oil level is between the
upper and low marking of the oil level
gauge (approx. 10 Litre)
call your service partner
Lower the lift in the lowest position.
Remove the covering operating unit.
Switch off the main switch.
Remove the valve and clean it.
Problem: The lift does not lowered!
Potential causes:
Repair failures
The rail is sitting on a object. The lift stops through the
mechanical resistance.
The fuse is defective
The way valve is defective
Raise the lift with the button “▲“ until
the object can be removed.
Check it or exchange it
Carry out a emergency lowering. (read
chapter emergency lowering)
Remove the vehicle. Remove the valve
and clean it. If necessary exchange it.
6.1 Lowering on an obstacle
If the automotive-lift is lowering on a obstacle, the lift stops automatically. In this case press
the button “lifting”, until the obstacle can be removed.
6.2 Emergency Lowering
A emergency lowering is an intervention into the control of the lift and can be
planned only by experienced expert.
The emergency lowering must be carried in this order. Otherwise a malfunction can
lead it to damages or lead to danger for body and lives.
• Check the dangerous places of the lift and be sure that there are
no objects or people in the immediate area of the lift or on the lift.
• Switch off the main switch
• Loosen and remove the front cover of the operating unit.
• Press the black cap of the valves simultaneously down. The
lowering process starts.
• Observe the complete process.
• Lower the lift in the lowest position.
• Remove the polymer supports.
• After the emergency lowering, the lift must shut down until the
defective parts has been changed.
To Next Page
Loading...
Need help?
General
