Operating Instruction and Documentation
Sprinter Mobil 3000
- 23 -
5.2 Lowering the vehicle
• Check all danger points of the lift and be sure that there are no objects or people in the
working area (danger area) around the lift or on the lift.
• Lower the lift to the required working height or to its lowest (or fully collapsed) position.
Press the button “lowering”
• Do not lower the lift in the lowest position if the vehicle is without wheels. Otherwise the
lift cannot raise, due to its geometry, the vehicle under its own power.
• Observe the complete lowering process.
• If the lift is in its lowest position, remove the polymer supports.
• Drive the vehicle out of the lift if the lift is in the lowest position.
5.3 Change the installation place
• Lower the lift in the lowest position.
• Drive the vehicle from the lift.
• Raise the lift on a height of approx. 500mm.
• Use the mobile set. Put in the steering roller and the fixed roller.
• Lower the lift into the lowest position. Simultaneously, the base-plates lift themselves.
• Now the automotive-lift is movable.
• Remove the steering rod , if the lift is on the new place.
• Remove the mobile set.
6.Troubleshooting
If the lift does not work properly, the reason for this might be quite simple. Please check
the lift for the potential reasons mentioned on the following pages. If the cause of
trouble cannot be found, please call the technical service. We guess, to contact the customer
service also with simple disturbances.
Problem: Motor does not start
Potential causes:
Repair failures
No power supply
The main switch
Press button “▲” is defective
The Fuse is defective
The motor is defective
Check the power supply cable
Check the switch
Check the lifting button
Check it or exchange it
Call the service partner
Problem: Motor starts, lift does not lifting!
Potential causes:
Repair failures
The vehicle is too heavy
Unload the vehicle.
To Next Page
Loading...
Need help?
General
