NUTOOL MPK1200 - OPERATING INSTRUCTIONS; USING THE PARALLEL GUIDE (PIC.15); DIRECTION OF CUT (PIC.16); REPLACING THE CARBON BRUSHES (PICS.17 & 18)

19
GB
TECHNICAL SPECIFICATION NR1200
Voltage 230V ~ 50 Hz
Motor 1200W
Collett 8 mm e 6 mm
Velocità variabile 11500-30000min
-1
Plunge depth 44 mm
SoundPressureLevel
L
PA82,23dB(A)
SoundPowerLeve
L
WA95,23dB(A)
VibrationLevel 3,84 m/s
2
Weight 5.5 kg
(pic.20).LeadtheRouterwithalightsidepressurealongthe
edge of the piece to route.
DIRECTION OF CUT (PIC.16)
Inordertoavoid“bitchatter”andtoobtainthebestresults,cuts
needtobemadeinananti-clockwisedirectionforexternalcuts
andaclockwisedirectionforinternalcuts(Pic.16).
REPLACING THE CARBON BRUSHES
(PICS.17 & 18)
IftheperformanceofyourRouterispoororthereisexcessive
sparking visible through vents on top of the machine the carbon
brushes need replacing.
Removethetwocrossheadscrewsthatsecurethebrushcover
(Pic.17).Carefullyremovethecover.
Locate the brushes (one each side) and lift upwards and
outwards. Be careful not to disturb any wiring. Hold the black
outercasing(18.1)andremovethespringloadedcarbonbrush
(Pic.18).
Alwaysreplaceinpairsobtainablefromyourstockist.Re-fitthe
carbonbrushesandplacebackintoposition.Repeatoperation
for other side.
Ensure that the machines ventilation slots are kept clear
of sawdust/chippings etc. Keep plunge guides clean and
lubricated with a light multi purpose oil. There are no other user
serviceable parts in this unit.