NUTRIBULLET TRIPLE PREP SYSTEM - Page 27

5352
1 Make sure your Motor Base is
powered o and unplugged
from its outlet.
2 Detach the Cup, Pitcher, or
Work Bowl from the Motor
Base.
3 Clean the individual
components as follows:
EXTRACTOR BLADES:
• Use a small brush or sponge
dampened in soapy water to
remove any residue from the
Extractor Blade.
NOTE: It’s best to clean the Extractor
Blade immediately after use to avoid
the buildup of residue.
MOTOR BASE:
• Use a warm sponge or
dishcloth dampened with
soapy water to clean the
surface of the Motor Base.
• Use a small brush to scrub the
actuator system of the Motor
Base.
OTHER ACCESSORIES:
The following components are
dishwasher-safe:
• Blade Adapter
• Blade Attachments
• Cups
• Food Pusher
• To-Go Lids
Rinse or scrub beforehand to
remove any debris.
BLENDING PITCHER:
• The Pitcher and Pitcher Lid are
dishwasher-safe. if preferred,
hand wash using soap and
water. The blades are sharp.
Take care not to touch while
washing by hand.
TAMPER:
• Always wash the Tamper by
hand with soap and water.
WORK BOWL:
• The Work Bowl and Work Bowl
Lid are dishwasher-safe. If
preferred, hand wash using
soap and water. Be sure to
remove any Blade Attachments
or Discs as well as the Blade
Adapter before washing.
WARNING! NEVER wash your
nutribullet
®
part or accessory
using the sanitize or heat
cycle of your dishwasher.
Doing so can warp the part,
which can create hazardous
conditions during use that
may result in bodily injury or
property damage.
STUCK INGREDIENTS:
• To remove stubborn residue
from the Cups or Extractor
Blades, fill your Cup with
room-temperature water
to the MAX line and add 1-2
drops of dish soap.
• Twist on the Extractor Blade
and blend for 20-30 seconds
to loosen debris enough to
scrub away with soap and
water.
• To remove stubborn residue
from the Blending Pitcher, fill
halfway with water and add
1-2 drops of dish soap. Blend
for 20-30 seconds to loosen
debris enough to scrub away
with soap and water.
STORAGE:
• Always store your nutribullet
®
upright with nothing on top of
it. Store accessories in a safe
place until use.
• You can store the food
processor components
within the Work Bowl. Place
the Blade Adaptor on the
center shaft, followed by
the Chopping Blade, Dough
Blade, and lastly, the Slice/
Shred Disc. Attach the Lid
once all components are in
place.
• NEVER store or leave Blades
or Discs exposed. Always
cover with appropriate lid or
cover.
For replacement
parts:
Periodically inspect your
nutribullet
®
for damage or
wear. Never operate if any of
the parts and accessories are
damaged in any manner which
may impair proper function or
create a safety hazard. Contact
Customer Service for assistance
at nutribullet.com.
Use only genuine nutribullet
®
attachments/accessories
specifically designed for your
nutribullet
®
Triple Prep System.
Aftermarket parts are not made
to nutribullet
®
specifications and
may damage your unit or cause
serious injury.
Visit nutribullet.com/shop/
accessories.