12
Figure 4
6. OPERATING PRINCIPLES
6.1. OPERATING THE UNIT
Switch on BM series stirred water bath by using the power switch and ensure that the
power switch led is on.
Observe that command and display panel is activated.
Learn the functions of command and display panel (see. Section 5.7).
Set the values and start the operation.
Please check of the liquid level in the tank during long operations and refill to the may
line if necessary.
6.2. PROGRAMMING
Push the temperature set key.
Set the temperature by pushing the value increase/decrease keys on the
temperature adjustment side.
Push the temperature set key again to save the temperature value.
To Next Page
Loading...
