4.4. MAIN SUPPLY
The centrifuge requires 230 V, 50 / 60 Hz. Please make sure that the supplied mains match
the required power ratings. If no, provide an extra line to support.
SECTION 5 – OPERATING UNIT
5.1. OPERATING
Open the lid and check that there is no sample in the instrument.
Turn the centrifuges on by using On/Off switch.
See that the display and control panel activates.
Learn the functions of the control panel.
Set the values and start the operation.
5.2. DISPLAY AND CONTROL PANEL
According to the standard IEC 61010-2-020, anyone and any
hazardous materials should not be in the 300 mm safety zone while
centrifuge is running.
The centrifuges are designed to operate safely under the following
conditions:
- Indoor use only
- Ambient temperature: 5
°
C to 25
°
C.
- Maximum relative humidity of 80% for temperature up to 22 °C.
- Maximum altitude: 2000 m.
- Temperature for maximum performance: 15 °C / 25 °C.
Always plug the sterilizer/ovens to properly earthed sockets.
A supply fitted with a circuit breaker should be used for protection
against indirect contact in case of an insulation fault.
To Next Page
Loading...
