INPUT OUTPUT
Power Input
LIFT toggle
INSERT
INPUT
Use a shield cable to connect a guitar to
Stageman Floor. You can adjust the input signal
according to the type of pickup used.
LIFT toggle
Disconnect the grounding pin from the ground.
This is effective if noise is caused by a ground
loop.
OUTPUT
Connect to the amplifier, interface, or mixer.
USB
PIEZO-MAGNETIC toggle
Control Panel
SCOOP toggle
While Scoop toggle is “UP”, it cuts middle
frequency.
NOTCH toggle
Engages Notch function.
Chorus Foot Switch
Engages Chorus function. Hold it for Freeze
function.
Preamp Foot Switch
Engages Preamp function.
I/O Jacks
- Press Chorus and Preamp foot switches
simultaneously to enter/exit Loop Mode.
- Preamp foot switch becomes REC/PLAY/DUB
control. Reverb knob becomes Loop level
control.
Press Once
OVERDUB
PLAY
REC
Hold
REDO
UNDO
PLAY
Loop Mode
PLAY
Press Twice
STOP
Press & Hold
CLEAR
PIEZO-MAGNETIC toggle
Select according to the type of pickup you use.
To Next Page
Loading...
Need help?
General
