must be placed on an antistatic surface.
For package contents, please refer to Package Contents.
Pre-Installation Checklist
1. Verify that your system meets the hardware and software requirements
stated above.
2. Shut down your system if active.
Turn off the power to the system, and disconnect the power cord. Refer to the
system documentation for instructions. Before you install the DPU, make sure that
the system is disconnected from power.
Installation Instructions
This section provides detailed instructions on installing your DPU in a system.
Important
Please note that if the card is removed hastily from the antistatic bag,
the plastic ziplock may harm the EMI fingers on the networking
connector. Carefully remove the card from the antistatic bag to avoid
damaging the EMI fingers.
Warning
Please note that the following figures are for illustration purposes
only.
To Next Page
Loading...