Nvidia ConnectX-6 - Software Requirements; Safety Precautions; Pre-Installation Checklist; Bracket Replacement Instructions

27
•
•
•
•
•
•
•
•
•
Software Requirements
See Operating Systems/Distributionssection under the Introduction section.
Software Stacks -NVIDIA OpenFabric software package MLNX_OFED for Linux, WinOF-2 for
Windows, and VMware. See the Driver Installationsection.
Safety Precautions
The adapter is being installed in a system that operates with voltages that can be lethal. Before
opening the case of the system, observe the following precautions to avoid injury and prevent
damage to system components.
Remove any metallic objects from your hands and wrists.
Make sure to use only insulated tools.
Verify that the system is powered off and is unplugged.
It is strongly recommended to use an ESD strap or other antistatic devices.
Pre-Installation Checklist
Unpack the ConnectX-6 Card; Unpack and remove the ConnectX-6 card. Check against the
package contents list that all the parts have been sent. Check the parts for visible damage
that may have occurred during shipping. Please note that the cards must be placed on an
antistatic surface. For package contents please refer toPackage Contents.
Shut down your system if active;Turn off the power to the system, and disconnect the power
cord. Refer to the system documentation for instructions. Before you install the ConnectX-6
card, make sure that the system is disconnected from power.
(Optional) Check the mounting bracket on the ConnectX-6 or PCIe Auxiliary Connection
Card;If required for your system, replace the full-height mounting bracket that is shipped
mounted on the card with the supplied low-profile bracket. Refer to Bracket Replacement
Instructions.
Bracket Replacement Instructions
The ConnectX-6 card and PCIe Auxiliary Connection card are usually shipped with an assembled
high-profile bracket. If this form factor is suitable for your requirements, you can skip the
remainder of this section and move toInstallation Instructions. If you need to replace the high-
profile bracket with the short bracket that is included in the shipping box, please follow the
instructions in this section.
Please note that if the card is removed hastily from the antistatic bag, the plastic
ziplock may harm the EMI fingers on the networking connector. Carefully remove the
card from the antistatic bag to avoid damaging the EMI fingers.
