Nvidia ConnectX-6 - Page 38

38
Step 5:Slide theCabline CA-II Plus harnesses through the retention clip. Make sure that the
clip opening is facing the plugs.
Step 6:Plug the Cabline CA-II Plus harnesses on the PCIe Auxiliary Card. As indicated on
bothsides of the Auxiliary connection card; plug the black harness to the component side and
thewhite harness to the print side.
Step 7:Verify the plugs are locked.
Step 8:Slide the retention clip through the cutouts on the PCB. Make sure latches are facing
"Black Cable" annotation as seen in the below picture.