*Please note that the accessory list above covers all items expected to be included in the SC HYBRID Kit. It is
possible that you may receive extra accessories that will go unused after completion of the installation manual.
Please follow all directions carefully, and contact EVGA Customer Service if you have any missing accessories or
questions.
See the instructions below.
01. Remove the backplate from the card
(a) For Founders Edition #A, remove 16 screws on the back side of the card. Use a Phillips #1 screwdriver for the 2
screws near the bracket, circled in yellow, and a Phillips #0 for the remaining 14, circled in red. This allows the
backplate to be removed. Carefully set these aside, as these screws will not be used again.
(b) For Blower and iCX models #B, #C, #D, remove the 16 screws circled in the picture below, using a Phillips #1
screwdriver. This allows the backplate to be removed. Carefully set these aside, as these screws will not be used
again.
2. For Founders Edition (#A), remove the screws circled on the bracket below with a Phillips #1 screwdriver and set
the screws aside, as these will not be used again.
To Next Page
Loading...
