9. Install pump
For all cards, carefully remove the plastic cover over the #3 pump without touching the thermal grease. Install the
pump over the memory baseplate, as shown in the left photo below. Place the radiator fan wire in the middle of the
grooves. Next, turn the card over while holding the pump in place. Fasten the pump to the card using 4 #8 spring
screws, as shown in the right photo below:
10. Install pump power cable
(a) For all cards, run the power connector with a Y adapter around the tube and pump. Next, use #5 acetate tape and
a #16 cable tie (if necessary) to secure the wire (See left photo). Run the wire under the groove of the MOSFET
heatsink and plug the power adapter into the fan header. Use acetate tape to secure the wire to the heatsink (See
middle photo). Finally, plug the MOSFET fan cable into the passthrough connector (See right photo).
11. Connect LED wire and install shroud
For all models, connect the LED cable to the card based on the type of graphics card used:
1. 2 Pin: Plug into O if you have (#A,#B,#C) models
2. 6 Pin: Plug into 8 if you have (#D) models
To Next Page
Loading...
