NZSAT WIND UP - Parking Dish for Travel; Parking Procedure; Important Warning and Disclaimer

3
Parking dish ready to travel
STEP 1. Set Lock-Unlock lever to UNLOCK position. (Fig C)
Fig C
STEP 2. Rotate the dish direction pointer to the rear of your vehicle.
(which should be the arrow between LOCK & UNLOCK, if installed correctly)
STEP 3. Set Lock-Unlock lever to LOCK position to keep dish in it's parked position.
STEP 4. Wind the dish down CLOCKWISE until it's folded right down onto the LNB Arm Cradle on top of
your vehicle. The Elevation Meter should now indicate that the dish is parked.
STEP 5. Fold winding handle away.
STEP 6. Visually check outside to make sure your NZSAT Wind-Up is folded down in the Park/Travel position.
IMPORTANT
NB. If you drive away with the dish still elevated at a speed
above 15km/h a WARNING ALARM will sound.
STOP and park dish correctly.
Disclaimer:
This is only as a backup! This should not be relied upon as normal
operating procedure is to park the dish prior to moving the vehicle.