EasyManua.ls Logo

NZSAT WIND UP - Troubleshooting; Signal and Picture Issues; Dish Movement Problems; Elevation Meter Faults

Default Icon
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
Troubleshooting
FAULT
POSSIBLE CAUSE
1.NO signal, quality or picture.
Not aligned correctly.
Not on correct input on TV.
Parked under an obstruction.
Bad or faulty connection.
Faulty LNB.
2.Dish doesn’t rotate or rotate easily, or
doesn’t wind-up or wind-up easily.
Inspect dish on roof for signs of visible damage.
Cables may be binding/tangling while turning.
Contact your nearest NZSAT Wind-Up dealer.
3.Elevation Meter will not display anything.
No power getting to meter.
Powered ON
Elevation as you wind it up
Reference elevation &azimuth
guide for where you are.
Maximum elevation (stop winding).
Dish is in upright position
WARNING ALARM will be heard.
Elevation sensor not connected.