Page 2 of 6
800-1060 Rev: A
Device Settings
Continuous flow settings of 0.5 to 3.0 LPM.
Pulse dose settings of 0.5 to 6.0 in the following volumes:
External Power
Handle Operation
To use the AC power supply, connect
the power cord to the AC power
converter (brick). Then connect the
power supply to the Independence
and wall outlet. The external power
source icon will be displayed on the
control panel.
The DC power supply powers the
Independence from a vehicle’s 12/15-
volt DC outlet in all settings.
DC power is not sufficient to charge
batteries at all settings. Charging will
not occur at settings higher than
Continuous 2.0 or Pulse 4.0.
Press button to unlock handle.
Begin rotating and release button;
handle will re-lock in open/close
position automatically.
To Next Page
Loading...
