Oakcastle CD-150 - Basic Operation; Powering On;Off and Charging; Playback Modes and Settings

7
EN
USB IN AUX IN POWER
OFF ON
DC IN 5V
Basic Operation
Basic Operation
Each time the REPEAT button on the remote control is pressed, the order of the tracks
played will be as follows:Repeat1(REP1), Repeat all(ALL), random play(SHUF).
CD
01:25
REP1
CD
P02
Set A Ab ON Ab OFF
CD
POP
4. How to Program the Play
5.. How to setup EQ effect
6. A-B Repeat
Press the EQ button to changes the different sound effects. There are a total of 5 sound effects:
BBS, POP, JAZZ, ROCK, and CLASSIC,FLAT.
3.How to setup the Circle Mode
1. How to Turn the Player on/off.
A.the power switch is located on the side. Please toggle it to ON position to play normally.
B.the power switch is located on the side. Please toggle it to OFF position to turn it off.
2. How to Charge for the Player
Connect the supplied USB charging cable with the power adapter, then plug it into a power
source to charge the player. OR Connect the supplied USB Charging cable to a computer/
desktop/car charger/power bank to charge it.
Charging Time: It will take about 4 hours for a full charge. When charging, the charging indicator
on the player will be RED. Once the player is fully charged, the indicator will turn to GREEN.
NOTE: When the player is in low battery, the LCD screen will be flashing. Please charge it.
Press the PROG button to enter the programming mode when the play stops, press the PREVIOUS or NEXT button
to select the track you want to program, press PROG again to confirm the programming.
Up to 20 tracks can be programmed in this mode. After that, press the PLAY button to enter the programming play
mode. Press the STOP button directly to enter the stop mode to cancel or reprogram.
A. During playback press "A-B" to set the Staritng Point A.
B. Press "A-B" a second time to set the Ending Point B and player will repeatedly play the
part between Point A and Point B.
C. Press "A-B"a third time to cancel "A-B" repeat and resume normal playback.