Why is the water flow insufficient in my Oase Water Filtration System?
Several factors can cause insufficient water flow in your Oase Water Filtration System. The impeller unit, foam filter, filter media, or pipework might be soiled and require cleaning. The inlet strainer could be clogged and needs to be cleaned. The impeller unit may be worn and need replacement. Ensure that the water flow is correctly set.
What to do if my Oase Water Filtration System does not start up?
If your Oase Water Filtration System doesn't start, first check the mains voltage. If the voltage is ok, the impeller unit might be blocked and needs cleaning. Another cause could be air trapped inside the filter, in this case, vent the filter by moving it from side to side to release any trapped air.
How to improve the filtering performance of my Oase BioMaster 350?
Poor filtering performance in your Oase Water Filtration System can stem from a soiled or worn foam filter in the pre-filter, or from soiled or worn filter media in the filter unit. Clean soiled components or replace worn ones to restore optimal performance.
Why is the water heating insufficient in my Oase BioMaster 350?
If your Oase Water Filtration System (with heater) isn't heating water sufficiently, the heater may be defective and require replacement, or it may not be calibrated correctly and need calibration. Also, ensure the water temperature is correctly set on the heater. Insufficient water flow can also cause this issue; refer to the troubleshooting steps for 'Water flow insufficient'.
How to reduce noise from my Oase Water Filtration System?
Increased noise in your Oase Water Filtration System is often due to air trapped in the filter. To resolve this, move the filter from side to side to allow the remaining air to escape.
What to do if the Oase Water Filtration System cannot be vented?
If you're unable to vent your Oase Water Filtration System, the valve box in the pre-filter may be blocked and require cleaning. Also, ensure the filter is installed below the surface of the water.
Essential safety guidelines for proper and safe operation of the unit.
Guidelines for use by children and persons with reduced capabilities.
Instructions for safely handling, removing, and fitting the heater.
Instructions for removing and reassembling the unit head.
Procedure to prime the filter and remove trapped air for proper operation.
Steps for powering on and off the filter unit, including heater safety.
Lists potential issues like no start-up, low flow, and their solutions.
General| Flow Rate | 1100 L/h |
|---|---|
| Suitable for Aquariums | Up to 350 liters |
| Pre-filter Module | Yes |
| Power Consumption | 15 W |
| Hose Connection | 16/22 mm |
| Cable Length | 1.5 m |
| UV-C Clarifier Included | No |
| Filter Type | External Canister Filter |
To Next Page