EN
51
Replacing the cleaning rotor
On the FiltoClear 19000 und FiltoClear 31000, an additional cleaning rotor is positioned above the
quartz glass to clean the quartz glass with the aid of the water flow.
Replace the cleaning rotor when it is worn.
Prerequisite:
The quartz glass has been removed. (→ Cleaning/replacing the quartz glass)
How to proceed:
Check the profile wear at both ends and the inner surfaces of the cleaning rotor.
– If the profile is worn, the cleaning rotor will rotate sluggishly and has to be replaced.
Insert the cleaning rotor in the UVC water housing.
To Next Page
Loading...
Need help?
General
