- EN -
74
7.21 Updating the firmware
For a firmware update, the FM-Master WLAN changes to the firmware update mode and provides a new net-
work. Your smartphone/tablet has to be connected to this network for installing the update.
NOTE
P
rerequisites for a malfunction-free firmware update:
Other WLAN connections to the FM-Master WLAN are disconnected.
The WLAN connection has a strong signal.
The FM-Master app is not closed during the update.
The power saving mode of the smartphone/tablet is deactivated.
The smartphone/tablet battery is sufficiently charged. The update takes up to 2 minutes.
The power supply of the FM-Master WLAN is not interrupted.
How to proceed:
1. Tap ne
xt to „FM-Master Firmware“.
The touch symbol is only displayed when an update is available.
2. Confirm the notes for a malfunction-free firmware update.
FM-Master WLAN switches to firmware update mode and confirms the switch with an acoustic signal.
FM-Master WLAN makes the network „OASE_UPDATE_xxxxxx“ or „OASE_UPDATE_EGC_xxxxxx“ availa-
ble.
An instruction for changing the network is displayed.
3. Connect your smartphone/table with the network „OASE_UPDATE_xxxxxx“ or
„OASE_UPDATE_EGC_xxxxxx“.
Use the standard password of the FM-Master WLAN for the prompt (see device type plate).
4. Switch to the "Settings" screen of the app and confirm the instruction.
The update is started.
The progress of the update is displayed.
5. After a successful update, re-connect the smartphone/tablet with the WLAN of the FM-Master WLAN.
7.22 Displaying unit information
Displayed information:
App version of the FM Master App
Firmware version of the FM-Master WLAN
Touch "Further information" to display the following information:
Ser
ial number of the FM-Master WLAN
Local IP address
IP address of the FM-Master WLAN
Touch Product informations / FAQ to access the OASE website for further information about the product and
help with problems.
Downloaded from www.watergardeningdirect.com
To Next Page
Loading...
Need help?
General
