3/8” pilot drill and either a step drill bit up to 7/8” diameter that
will drill through SS top or 7/8” diameter punch die (retrofit
version only)
Electric drill; wrench for punch die
Small tubing cutter for copper tube
1/4“ nut driver
# 2 Phillips screw driver
#15 torx bit driver
38” of ¼ OD plastic
tubing with 19” of
sponge tubing
insulation
(included
with “Versafiller ready”
coolers)
Anti splash grate
Drip tray
What’s Included:
Tools required:
Installation
instructions
Section 1: Getting Started
Anti Splash
grate screws (2)
Snap bushing
Quick connect
tee fitting
(only
required on split
level units)
(Top cap)
VersaFiller Hands-Free
Sports Bottle Filler-
(with wrapper, alcove
and top cap installed
onto the frame)
Gasket
To Next Page
Loading...
