Oberheim Matrix-6 - 15 PATCH MAP; 16 P MAP EDIT - Patch Map Edit

MT9
KZh? fe accomj"fed ** usi"3 the Table" in Parameter 16 P MAP EDIT to make the
respond to any patch you want reaardtes<$ of whai d^4«u *, ,. «o mane me
15 PATCH MAP
This parameter simply turns the MATRIX-6's Patch Mapping feature ON or OFF
5KHSaaS
n Ihe system. Remember .ha. 03 PATCH CHANGES mus. be turned ON
,o
16 P MAP EDIT- "Patch Map Edit"
1. To enter the Patch Map, press the VALUE button.
2. The display will read "READY?".
MapCOn(i9uralfon^P'aved.We
i^
The display fe divided into three sections, described as follows:
Pressing the first grey button under the display selects this parameter.
2. The second part of the display reads IN = XX. This is the MATRIX-6's Patch Number that will
Pressing the second grey button under the display selects this parameter
The third grey button is not active in this mode and is ignored if pressed.
= XX. This is the MIDI Patch Number that the MATRIX-6 will
fr^m tho matdiv c , second slave in the line if the Reference Patch Number is selected
from the MATRIX-6's front panel. "XX" is any desired MIDI Patch Number 00 through 99.
Pressing the fourth grey button under the display selects this parameter.
MATRIX-6 Revision 2.13 Owner's Manual Addendum
ECC/Oberhelm - Los Angeles, CA 90064 Part #950062 «
■■■ —. Page 8