Oberheim Matrix-6 - Page 18

Voice 1 Voice 2
(BASIC CHANNEL)
MIDI MONO CHANNELS
Voice 3 Voice 4 Voice 5 Voice 6
MIDI MONO also operates in SPLIT Mode and the MIDI Channel / Voice assignments conform
values listed in the table above for 2/4 and 4/2 Splits. For 0/6 and 6/0 X^^^
the
When MIDI MONO is enabled, a number of changes to its internal MIDI system are made automatically:
1. MIDI MONO overrides the following settings:
^MATp.y« t?een|s.elecJfd in pATCH Edit Parameter 48 KEYBOARD MODE is ignored and
the MATRIX-6 is put into ROB Mode. This does not alter the programming of your patches -the
programmed Keyboard Mode is only ignored as long as MIDI MONO is used.
°N'
MATRIX*6 wiI1 use onlV slx adjacent MIDI Channels
If SPILLOVER is ON, it will be disabled.
2. If J-EVER1 PEDAL1 and PRESSURE information are received from the Master controller thev will
affect each Voice independently. This means, for example, that you can use Rch Bend a^d
Volume on one Voice and not the others, or on two or three Voices, etc. without hav no to a"fec? an
n17±1°U rff?^t want. VELOCITY and RELEASE VELOCITY, being transmi ted w'h MJD
Notes, always affect each Voice independently.
3. If LEVER2 and PEDAL2 information are received from the Master controller, they will effect each
Voice globally This means, for example, thai Vibrato or Sustain Pedal commands affect all Voices
- they are not independent per Voice. •
4. MIDI MONO tea "MIDI Receive" function only. The MATRIX-6 will not transmit anything on six
JSffS.t, Channels. If MIDI MONO is ON, the MATRIX-6 will still transmit on the BASIC
CHANNEL N when in Single Patch Mode and on Channel N and N+1 when in SPLIT Mode
MATRIX-6 Revision 2.13 Owner's Manual Addendum
ECC/Oberhelm - Los Angeles, CA 90064 Part # 9500':2
Page 11