Oberheim Matrix-6 - ADDITIONAL MASTER EDIT PARAMETERS

ADDITIONAL MASTER EDIT PARAMETERS
4STRAN3POSE
This MATRIX-6 MASTER Edit parameter now permits you to transpose the entire instrument ud or
down .n the mode. Being a -Global- function. TRANSPOSE aflects all Sinale and STil
equal*. Thus if you se.ec. a TRANSPOSE Amount VALUE of + Ma^or iS'patches and SPUTS wi«
be transposed up by a Major 3rd. SPLIT palches that were programmed with 1LEFT TRANSPOSE
and/or 4 RIGHT TRANSPOSE used will be further transposed by whatever Armunt you selected in thi!
fr?71"6.3.t0 *6l wh?re each incremem of 1 represents one semi-tone of transp^e This
^l0 T"9 1°"W ?*?" °'tranSp0Se Which does not lake inl° co^id.fo
fon
> Masler Tune of SPL'"
More Tricks....
ih»°^,?reUPdalin9 V0Ur MATRIX"6 'rom 1 04 S°'waf5 (^eck MASTER Edit "54 SOFTWARE VERSION")
the following parameters were added in Rev. 1.05 and retained in this 2.13 Software Revision
44STANDOFF
This parameter controls the threshold of the Pressure sensor of the Keyboard. VALUE Ranae is 0 to
+63 Ra,s,ng his value increases the amount ol pressure or after-touch on the kevS that fe
&?££ y aC"Vale 'he Se"SOrThiS Pem"1S Ihe CUSlOmizin9 ol Pressure ^yb°^
Sources 15 PRESSURE . It is very important that you understand this distinction.
57SQUICK
SqTck T*£rTeXV?? S™TC"-Q[jM> <^P'ayed as "57 SQUICK-, has been added. When
EDi™5l?K^ILUfnit^riCll?Sf nOrma"y' When SQUICK is ON' when the unit h In PATCH
nnlini ? k?1 the imCllOn °f lhe arrows and U)e ke^ad ls ™***i. This means that the keypad
now selects which parameter to edit and the arrow keys change the value of a parame er Thfe S
will be remembered by the MATRIX-6 until changed and is not lost when power CST
MIDI Memory Protect
PROTECTED briefly and ignore thu rest oUhe incoming data.
CHANGES OF OPERATION
54 SOFTWARE VERSION
ih/rTir,^rrt ^f y°u^MATRJX-6. as we f^ve already dicussed, is a computer that handles
the calculations required to perform the various functio f th thi T
^f y^J. e already dicussed, is a computer that handles
required to perform the various functions of the synthesizer. The processor works
according to a pre-programmed set of operating instructions called "software". Software can be altered
at any time by Oberheim to reflect improvements or additions to these operating instructions
i0^reVlSed' 3 "eW]ndeX numbtr is assIgned t0 the revlsion- Thjs ls k^wn as the
MATRIX-6 Revision 2.13 Owner's Manual Addendum
ECC/Oberheim • Los Angeles, CA 90064 Part #950062 D -o