Observator Instruments OMC-183-ML - Display Calibration Values

OMC-183-ML Manual Page 17
Command E: With ‘E’ the calibration values stored in the device can be requested
Current Input 2 (pin 60):
0 mA value: 407
24 mA value: 63055
Current Input 3(pin 63):
0 mA value: 421
24 mA value: 63132
Voltage Input 3(pin 66):
0 Volt value: 536
5 Volt value: 64310
Voltage Input 4(pin 69):
0 Volt value: 536
5 Volt value: 64309
Always use the ‘Q’ command “Save and exit menu” if you change anything.
Without your changes might be lost once the power is switched off!
After changing ‘baud rate’ reboot device as well.