OMC-183-ML Manual Page 6
2. Installation
The OMC-183-ML is designed to be used indoors. Find a suitable location with the required
power and run your cables for all sensors.
Typically you will find the following sensors:
- wind sensor (OMC-160, OMC-116, OMC-118, OMC-150 or OMC-115)
- temperature & humidity sensor (OMC-406, OMC-443 or OMC-448)
- barometric pressure sensor (OMC-506: preferable build in OMC-183-ML housing*)
Output:
- Observator Display line: OMC-140, OMC-138/139 OMC-938/939
- OMC-data Online / OMC-DOL-HMS
Typical configuration with OMC-160 wind sensor, OMC-406 temperature & humidity sensor &
(dual) barometric pressure sensor.
* The OMC-506 must be vented outside via a tube whenever it is build in the OMC-183 housing and
the room is pressurized. We recommend to use a pressure head OMC-509 at the outdoor end of the
tube.
The OMC-183-ML is the replacement of the OMC-183 and got similar functionality. The additional
connectors are used in the MeteoLink products, some of these connectors may be functional in the
OMC-183-ML but others got a different functionality when compared to the MeteoLink concept.
To Next Page
Loading...
Need help?
General