Oce PlotWave 900 Specifications

Océ
Double Decker
Pro stacker
Rising Above
Stack more prints, save precious time
Make your plotter workflow even more productive with the Océ Double Decker
Pro stacker. This high volume stacker can store up to 1500 sheets on two trays.
It works seamlessly with your Océ plotter to allow unattended operation. To
streamline your workflow automatic operation can be configured to match the
way you work.
Fast, high capacity stacker
Prints from your plotter are automatically
stacked in neatly aligned piles at very high
speeds. Two separate trays can hold up to
750 sheets per tray. This enables your plotter
to run unattended. If one tray is full, prints
are automatically sent to the other tray. If
both trays have reached their maximum
capacity, an audio signal will notify the
operator to remove the prints.
Easy tray selection
There are two ways to select the destination
for your stacked output. You can use the
manual switch to stack your output on the
upper or lower tray, or you can set it to auto-
matic. If it is set to automatic the system
will choose the tray automatically, allowing
you to switch trays between each job or set.
This way you can take out a set for finishing
without disturbing the printing process.
Convenient, unattended
operation
Your Océ plotter works seamlessly with
the Océ Double Decker Pro stacker
to allow unattended operation. When
running in continuous mode it will
switch trays automatically when one tray
is full. In addition, the printer will stop
automatically when the trays are full to
avoid wasting time and resources.
Quiet and compact
The Océ Double Decker Pro stacker runs
very quietly to make working conditions as
comfortable as possible. The stacker takes up
a small amount of floor space so it can easily
fit into offices with limited space. This makes
it easy to upgrade your Océ PlotWave 900 or
Océ TDS750 plotter with the Océ Double
Decker Pro.

Oce PlotWave 900 Specifications