- 9 -
To repeat the above procedure, or if the Configure
Network wizard does not automatically start, the network
can be connected by using the Configuration mode.
1) Press the [ ] button to go to the mode selection
options
2) Select Configuration
3) Select Network
There are two different options to connect to the network
from the Configuration mode:
1) Repeat steps 1) through 5) above page 8.
2) Select Add AP (WPS button) – Press WPS button on
your router within 2 minutes to complete the
connection.
Connection status is displayed on the bottom left hand
corner of the LCD with the Wi-Fi symbol and signal
strength bars ( ).
For best Wi-Fi performance, limit “drop outs”
(interruptions) the Wi-Fi Channels must be set according
to the location of the Radio e.g. China, USA, Europe. The
factory default is China.
To set the correct location, select
Configuration>Network>Wi-Fi Channels and select the
correct option.
Network Setup
To Next Page
Loading...
