29
• Press and release the Side (Select) button until the desired
Depth Alarm value appears; or press and hold to scroll
through the set points.
• Press the Front (Advance) button to accept the setting and
advance to Elapsed Dive Time Alarm, or press and hold Both
buttons for 2 seconds to revert to Surface Mode.
TO SET - ELAPSED DIVE TIME ALARM
(while in the Surface Mode)
Factory set for 3:00 (hr:min), the Alarm can be set to values
between 0:10 and 3:00 (hr:min) in increments of 5 minutes.
• Press Both buttons simultaneously, release when SET: 1
appears (2 seconds).
• Press and release the Front (Advance) button, FO2 appears
with the set point value flashing.
• Press the Front (Advance) button 2 more times.
• The graphic EdT, and Alarm and Dive Time icons appear
with the Elapsed Dive Time value flashing (Fig. 26).
• Press and release the Side (Select) button until the desired
Alarm value appears; or press and hold to scroll through the
set points.
• Press the Front (Advance) button to accept the setting and
advance to PC Interface, or press and hold Both buttons for 2
seconds to revert to Surface Mode.
Fig. 26 - Set Dive Time
ATR
O
2
To Next Page
Loading...
