BREAK-IN PERIOD
Operation During Break-In
A break-in period of 10 operating
hours or 300 km (200 mi) is required
for the vehicle.
Engine
During the break-in period:
-Avoid full throttle operation.
-Maximum throttle should not exceed
3/4.
-Avoid sustained accelerations.
-Avoid prolonged cruising speeds.
-Avoid engine overheating.
However, brief accelerations and
speed variations contribute to a good
break-in.
Brakes
New brakes will hot operate at their
maximum efficiency until their break-in
is completed. Use extra caution.
Belt
Anew belt requires a break in period
of50 km (30 mi).During the break-in
period:
void strong acceleration and
deceleration (throttle should not
exceed3/4).
Avoid pulling a load Avoid high
speed cruising.
BASIC PROCEDURES
Starting the Engine
The shift lever must be set to PARK
or NEUTRAL.
NOTE: For your convenience, an
override mode allows the engine to
be started with the shift lever in any
position. Press and hold the brake
lever(s) or the brake pedal while
pressing the engine start button.
Insert the key into the ignition switch
and turn it.
Press the engine start button and
hold until the engine starts.
NOTE:
- If engine does not start after a few
seconds, do not hold the engine
start button more than 10 seconds.
- Check if fuel is empty.
-See an authorized Lil Pick Up ATV
dealer.
Release the engine start button
immediately when the engine has
started.
NOTE: If the battery is dead, engine
cannot be started. Have the battery
recharged or replaced.
To Next Page
Loading...
