OdorStop OSAP5 - Page 8

8
Functions
Power Button
Press and purier will start in “Auto” mode.
Fan Speed Display
Displays the fan speed from 1 (low) to 5 (high).
Filter Button – Press and % of lter life remaining is displayed and
LED light below “% Filter Remaining” will illuminate. This light will
blink when the lter needs to be replaced. After replacing the lter,
hold the “Filter Button” down for 5 seconds to reset.
Filter/Timer Display
Displays the lter life/timer setting. Corresponding LED indicates
which function is displayed.
Timer Button
Press and timer is activated and LED light below “Hours Remaining”
will illuminate. Each press will increase the length of time the
purier will run in 1/2 hour increments up to 24 hours. Purier will
shut off after set time.
Light Button
Press and all lights will turn off/on.
Auto Mode Button
Press and purier will automatically optimize functions based on
air quality.
Lock Button
Press and hold for three seconds to turn the lock ON. With the lock
on, a rapid beeping sound will occur when any button is pressed.
Press and hold for three seconds to turn the lock OFF.
1
7
2
8
3
4
5
6