Calibration
2. If the pattern centering needs adjustment use the X and Y Position Sliders to center the pattern on the monitor.
3. To check the alignment of the right monitor. Click on the Right tab on the form and repeat the steps for the left monitor
alignment.
4. If changes are made in monitor sizing, save the changes to the system by selecting the File pull down menu and selecting
Save, then To System, then Both. The message ”
YOU MUST REBOOT THE SYSTEM IN ORDER FOR THE SAVED DATA
TO BE APPLIED TO THE SYSTEM
” will display. Click on “Ok”. Turn the 9800 system off, wait for about 10 seconds then
turn the system back on.
Monitor Light Settings
Note: For pre-OPIS system software, use the RUT utility CD.
Using the RUT Utility CD
1. Connect the RUT cable to the laptop and the back of the workstation.
2. Run the RUT program. From the Tools pull down menu select Connect, then Upload and Save to save all data from the 9800
to the laptop.
3. Select the Workstation Calibration form
4. Click on the Monitor pull down button; and select the Left monitor.
5. Select minimum light settings by clicking on one of the minimum brightness or contrast sliders.
Note: Click at the top of the pointer on the slider. This will help prevent inadvertently changing the setting when you select it.
When a slider is selected it will have a red box around it allowing you to use the right and left arrows on the laptop keyboard
to make fine adjustments.
6. Using a light meter verify that the black and white panels on the center of the monitor produce the following minimum light
levels:
73
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
