Replacement
6. Remove three nuts that secure Battery Charger heat sink to C-Arm chassis. Retain nuts.
7. Carefully lift Battery Charger PCB from studs that support heatsink.
8. Inspect replacement Battery Charger PCB for missing components or obvious damage.
9. Install replacement Battery Charger PCB onto mounting studs.
10. Install nuts removed in step 6 on mounting studs. Finger tighten only.
11. Install torx screws removed in step 5 through mounting holes at bottom of Battery Charger PCB.
12. Secure all mounting hardware
13. Connect wires removed in step 4 to P1, P2, and P3 on replacement Battery Charger PCB.
14. Adjust Battery Charger output procedure in Calibration chapter.
15. Install Component Tray cover removed in step 3.
16. Install Rear cover on C-Arm.
38
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
