Replacement
Fast Stop Switches
Cross Arm
Bearing
Cover
Fast
Stop
Switches
(1 each side)
Cross Arm
Side Cover
Fast Stop Switches
Follow these steps to replace a suspect Fast Stop switch.
1. Turn Workstation off and disconnect its AC power plug from the AC outlet.
2. Remove Cross Arm Bearing cover as described in the Equipment Covers section of this chapter.
5. Remove three screws from each end of the Control Panel that houses the suspect Fast Stop switch (six screws total).
6. Remove loosened Control Panel.
7 Remove suspect Fast Stop switch from loosened Control Panel.
8. Reassemble in reverse order.
55
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
