OEG EcoComfort - Setting Operating Time Periods

34 EcoComfort
. Operating modesSetting the operating mode
Adjustments in the mode “Time setting“
The two-digit display indicates the current time, when the pump is in
the mode “Time setting“. Hour and minute are displayed alternately.
Step :
Select the mode “ Time setting“
(You can set the timer in this mode only):
Press both buttons  and  at the same time for  seconds to
activate the setting mode. The -digit display flashes and shows the
period from F to F.
Step : Setting the current time and the operating time:
The operating time is set from F to F and is indicated in the
display in hours and minutes alternately.
F – F represent the following  time periods:
F Set current time
F Set start time of first operating period
F Set end of first operating period
F Set start time of second operating period
F Set end of second operating period
F Set start time of third operating period
F Set end of third operating period
After pushing button  for approx.  seconds, you will enter the
settings for time (LED  is on) and the current time is indicated.
High-efficiency drinking water circulation pump
GB